Shredder motor

Hi would this motor be strong enough?

Thanks
Gerd

80RPM at 1.1KW which is about ~1.75HP or so
that means it puts out about 1162 lb-in or 131.2 N-M of torque
that should work for thinner pieces of plastic just fine.

This looks like a 3-phase motor. Do you have a 3-phase supply?

I will add to the will this motor work group.

I found these motors in Melbourne Australia for dirt cheap. My untrained eye says they look like they will work, but it doesn’t hurt to double check

Link to motor

many thanks for information.

regards
Gerd